1. Home
  2. PRODUCTS
  3. BOXER Marine Paint Coal Tar Epoxy EPC-001
 BACK

PRODUCTS

BOXER Marine Paint Coal Tar Epoxy EPC-001

KEMBALI

Boxer Paint Coal Tar Epoxy Marine Paint EPC-001 is a high solids two-component paint combined with tar. This paint is specially formulated to be applied to steel or concrete surfaces in industrial or marine areas with extreme conditions. Provides excellent abrasion resistance, and excellent resistance to chemical immersion as well as salt water. This paint also has excellent rust resistant, excellent adhesion, quick drying, and heat resistance up to 120 degree Celsius.

SPECIALTIES

- High solids
- Excellent rust protection
- Excellent resistance to extreme weather condition
- Excellent abrasion resistance
- Excellent resistance to chemical immersion and salt water
- Heat resistance up to 120 degree Celsius
- Excellent resistance to salt and fresh water

Product Packaging

1 kg-set, 5 kg-set, 20 kg-set

Tokopedia

tokopedia icon

- Ensure the surface is thoroughly cleaned and free from any surface flaws. Check for areas of damage, separataion or peeling, or any other indications that the existing coating is not firmly adhered to the substrate. All surfaces must be dry at time of application.

- Stir the Base thoroughly beforehand. Then mix Base and Hardener with ratio 4 : 1 and stir for ±2 minutes. Apply only when air and surface temperatures are between 10-38°C for maximum result. For immersion service and severe environments, apply thickness as recommended. For application using airless spray, it is strongly recommended to apply 2 (two) coats with 80 - 200 microns per coat to achieve maximum result. For water immersion service, allow 7 consistent days prior to immersion service.


Type 2 component
Appearance Doff/ Matte
Color Black

Specific gravity (temp 30 ?C )

1.2 - 1.3 kg/lt
Solid Volume
Dilution BOXER Thinner Epoxy
Ratio of dilution - Ready to use
5 - 15% if needed
Ratio of hardener 4 (Base) : 1 (Hardener)
Film thickness Dry: 80 - 200 microns
Wet: 100 - 250 microns
Pot Life (30 oC) 6 - 8 hours after mixing

Touch dry (30 ?C)* 2 hours
Hard dry (30 oC) 16 - 24 hours
Recoating interval Min. 16 hours
Curing time (30 oC) 7 days
Recommended no. of layers 1 - 3
Method of application Brush, spray, air spray, airless spray
Theoretical coverage 8 - 10 m2/kg (DFT 80 microns)
4 - 6 m2/kg (DFT 200 microns)
Packaging 1 kg-set, 5 kg-set, 20 kg-set

Download the Technical Data below:

Download Technical Data